Observing some principles for proper set up is essential towards the reputable and right operation of your gearbox or gear motor.
The rules set out listed below are meant being a preliminary guide to deciding on gearbox or gear motor. For helpful and good set up, adhere to the directions offered inside the set up, use the maintenances manual for the gearbox readily available from our sales department.
Following is actually a short outline of installation guidelines:
a) Fastening:
Area gearbox on a surface giving satisfactory rigidity. Mating surfaces ought to be machined and flat.
Mating surfaces has to be inside of definite geometric tolerances (see manual). This can be specially genuine of flange-mounted gearboxes with splined hollow shafts.
In applications that involve higher radial loads on the output end, flange mounting is recommended for some gearbox sizes as this mounting helps make utilization of the double pilot diameters presented in these gearboxes.
Ensure the gearbox is suitable for your needed mounting position.
Use screws of resistance class eight.8 and more than to secure the gearbox. Torque up screws on the figures
indicated while in the relevant tables.
With transmitted output torque higher than or equal 70% of your indicated M2max torque, and with
regular motion reversals, use screws with minimal resistance 10.9.
Some gearbox sizes might be fastened using both screws or pins. Of pin seated during the frame the gearboxes be at the very least 1.five instances pin diameter.
b) Connections
Safe the connection elements to gearbox input and output. Do not tap them with hammers or similar equipment.
To insert these components, utilize the support screws and threaded holes offered over the shafts. Make sure to clean off any grease or protects in the shafts just before fitting any connection parts.
Fitting hydraulic motors.
Be careful the O ring among motor flange and gearbox input flange when assembling. Set up the
hydraulic motor ahead of filling lube oil to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit must be such to make certain that brake is released instants in advance of gearbox begins and utilized after gearbox has stopped. Check out that strain during the hydraulic line for brake release is at zero when gearbox is stopped.
Route of rotation
Motors are linked towards the suitable electrical or hydraulic circuit according to their path of rotation.
When doing these connections, bear in mind that all gearboxes, no matter if within the in-line or appropriate angle design, possess the similar route of rotation both at input and output. For additional details of your connection of electric and hydraulic motors, see relevant sections in this catalogue.