Power UNITS FOR LIFT TABLE one
General Description
This electrical power unit is intended exclusively for your modest lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become extensively made use of within the industry of logistic gadgets such as minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled from the solenoid valve using the velocity controlled by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Basic Description
This power unit is designed solely to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the speed controlled by the adjustable needle valve. When the lift rises to a higher positoin, but the power supply is lower, the lowering movement is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is created exclusively to the huge lift table, Consisting of highly 
effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the speed controlled by a stress compensated movement management valve.
Energy UNITS FOR LIFT TABLE four
Common Description
This electrical power unit is developed solely for your big lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve along with the velocity managed through the adjustable needle valve. When the lift rises to a higher positoin, but the energy provide is minimize, the decreasing movement is controlled from the guide override perform.
Exclusive Notes
1. This power unit is of S3 duty cycle, which can only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean each of the hydraulic elements concerned prior to installation of the power unit.
three. Viscosity in the oil shoud be 15~46 cst,which should also be clean and free of charge of impurities.N46 hydraulic oil is advisable.
four. Oil modifying is needed right after the initial a hundred operation hrs,afterwards when just about every 3000 hrs.
5. The electrical power unit proven is intended to be mounted vertically.
